Parts list:
| № | Number | Qty | Name | Options |
|---|---|---|---|---|
| 1 | SA35086 | 1 | Handle | |
| 2 | SA35023 | 1 | Screw | 30X8, EJOT KB |
| 3 | SA35503 | 1 | Screw | 60X20, DUO TAPTITE CM |
| 4 | SA34438 | 1 | Shield | |
| 5 | SA36453 | 1 | Orifice | |
| 6 | SA34452 | 4 | Screw | 6, 0X14, DUO TAPTITE CM |
| 7 | SA36116 | 1 | Sector | |
| 8 | SAA34592 | 1 | Lever | |
| 9 | SA36388 | 1 | Clamp | (SUB FOR SA15174) |
| 10 | SA29854 | 1 | Bolt | M5X12 |
| 11 | SA34282 | 3 | Push Nut | 8 |
| 12 | SA17006 | 2 | Pin Fastener | 6H11X13, 5 |
| 13 | SA12973 | 2 | Push Nut | D6 |
| 14 | SA36454 | 1 | Tie Bar | |
| 15 | SA35273 | 1 | Extension Spring | |
| 16 | SA34452 | 1 | Screw | 6, 0X14, DUO TAPTITE CM |
| 17 | SAU11287 | 1 | Axle | FRONT (SUB FOR SA34451) |
| 18 | SA36261 | 4 | Clamp | |
| 19 | SA34450 | 4 | Screw | 6, 0X10, DUO TAPTITE CM |
| 20 | SA35229 | 2 | Washer | |
| 21 | SAA37161 | 2 | Wheel | 180MM, FRONT |
| 22 | SA33229 | 4 | Ball Bearing | |
| 23 | SA15213 | 4 | Washer | A8, 4 |
| 24 | 14M7327 | 4 | Lock Nut | M8, (SUB FOR SA11998) |
| 25 | SA34531 | 4 | Cap | |
| 26 | SA34474 | 1 | Shaft | |
| 27 | SA34472 | 1 | Axle | REAR |
| 28 | SA35399 | 1 | Ring | |
| 29 | SA34285 | 1 | Bearing | |
| 30 | SA34279 | 1 | Guide | |
| 31 | SA34286 | 1 | Transmission | (ORDER DRIVE UNIT AS UNIT ONLY, PARTS NO LONGER SUPPLIED SEPARATELY) |
| 32 | SA31264 | 1 | Bolt | M5X16 |
| 33 | SA15412 | 2 | Nut | M6 |
| 34 | SA15232 | 4 | Lock Washer | A6 |
| 35 | SA15364 | 2 | Cap Screw | M6X12 |
| 36 | SA35432 | 1 | Retainer | LOW |
| 37 | SA36571 | 1 | Isolator | (SUB FOR SA35433) |
| 38 | SA35435 | 1 | Retainer | UP |
| 39 | SA31201 | 2 | Bushing | |
| 40 | SA35182 | 2 | Shield | |
| 41 | SA34284 | 2 | Driver | |
| 42 | SA13911 | 2 | Spring Washer | |
| 43 | SA13912 | 4 | Disk | |
| 44 | SAA37273 | 1 | Pinion | RH (SUB FOR SA34503) |
| 44 | SAA37273 | 1 | Pinion | LH (SUB FOR SA34504) |
| 45 | SA15864 | 2 | Snap Ring | 14X1 |
| 46 | SA35424 | 2 | Disk | |
| 47 | SA37164 | 2 | Wheel | 180MM, REAR |
| 48 | SA12316 | 4 | Needle Bearing | HK 1212 |
| 49 | SA34464 | 1 | Push Pull Cable | (FOR GROUND SPEED DRIVE) |
