CORE ACCEPTANCE CRITERIA IF THE RETURNED CORE HAS ONE OR MORE OF THE FOLLOWING CONDITIONS, ZERO CORE CREDIT WILL APPLY. CORES WITHOUT ANY OF THE FOLLOWING CONDITIONS WILL RECEIVE 100 PERCENT CORE CREDIT. 1. THE ASSEMBLY MUST BE COMPLETE AND INTACT. [ 105 CORE ACCEPTANCE CRITERIA AND RETURN PROCEDURES JDM Remanufactured Components and Core Identification Guide for Construction and Forestry Machines PC2345 in COMPONENT, REMANUFACTURED JDM

ALMA PRODUCTS AC COMPRESSORS NOTE: OIL THAT LEAKS FROM THE SKIP AREA OF WELD AT THE FRONT FLANGE AND MAIN HOUSING IS USUALLY OIL USED IN COMPRESSOR ASSEMBLY. USE A LEAK DETECTOR TO VERIFY FREON LEAKAGE. FULL CREDIT IS GIVEN FOR UNITS WHICH HAVE A [02

ALMA PRODUCTS CORE CRITERIA - CONTINUED THE SUPER HEAT SWITCH (A) IN REAR HOUSING HAS BOTH A PRESSURE SWITCH AND A TEMPERATURE BULB AND IS THE LEFT-HAND SWITCH IN THE ILLUSTRATION. IF THE SWITCH IN THE COMPRESSOR APPEARS LIKE THE RIGHT-HAND SWITCHES,

ROBERT BOSCH CORE CRITERIA ALL ROBERT BOSCH RETURNED CORES MUST MEET THE GENERAL CRITERIA POINTS 1, 2, 3 AND 4 ON PAGE 105-1 IN ORDER TO RECEIVE FULL CORE CREDIT. SEE CORE ACCEPTANCE CRITERIA REDUCED CREDIT WILL BE GIVEN TO REBUILDABLE CORES WITH MIS

CRITERIA FOR OTHER REMANUFACTURERS USE THE GENERAL CORE ACCEPTANCE CRITERIA ON PAGE 105-1 AT THE BEGINNING OF THIS SECTION FOR THE REMANUFACTURERS NOT MENTIONED ABOVE. [02I18]

HYDRAULIC PUMPS, VALVES OR COMPONENT CORE RETURN CRITERIA THE ASSEMBLY MUST MEET THE GENERAL CRITERIA SUCH AS COMPLETE, INTACT AND SHOW NO EVIDENCE OF IMPROPER STORAGE. EXCAVATOR HYDRAULIC PUMPS SHOULD HAVE THE AT125498 PILOT PUMP AND THE AT107262 PU

CORE IDENTIFICATION, COMPONENT WHERE USED AND RETURN PROCEDURES TO IDENTIFY A REMANUFACTURED COMPONENT PART NUMBER, LOOK AT THE COMPONENTS LISTED IN THE SECTION FOR THE COMPONENT. A LISTING OF MACHINES THAT USE THE COMPONENT FOLLOWS THE COMPONENT [02